- Make sure there is enough space on all sides

* 190–220°C (Diameter of 1

UltiMaker PLA 2

You can then just "pop" the model off the blank

PrintaClean - 250ml PrintaFix // Lim - Make sure there isPrintaClean 250ml PrintaClean If it's hard to get your glue off the building board, PrintaClean is the solution! PrintaClean can clean your building board. Allow the build plate to cool to room temperature. Then remove the build plate from the 3D printer and spray a generous amount of PrintaClean on it. Let it sit for 20 30 seconds to loosen. Wipe off any residue with a piece of paper. Repeat if necessary. PrintaClean If it's hard to get your glue off